Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kinjan
IT IS THE RATIO OF OUTPUT POWER TO THE INPUT POWER.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Why the output of OP-AMP is always less than Vcc?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
How to calculate or formula to calculate rhe power in 2 phase system ??
what is level 2 automation?
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
Give some differences between open loop and closed loop control systems.
what is star delta starter? how it works? give its control and power diagram.
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
Why is negative feedback invariably preferred in closed loop system?
The height to which the liquid in a tank to be maintained for a certain constant velocity?
