Interested to Buy Any Domain ? << Click Here >> for more details...
what happens when back feeding supply accidently collapses
with normal supply ??? How??
[that is sometimes in a substation 11kv feeder if their ws
long time permit work, back feeding supply will provide from
nearest substation... if accidently after the permit
work,they charged the feeder without removing back feeding
wat will happen...?]
- 1 Answers
- 4398 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / suresh kumar
There will be phase to phase short circuit fault & the
circuit breaker(VCB/OCB) installed will get tripped on both
sides supplies. This may result in heavy damage to contacts
points & breaker parts
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
Differentiate between digital phase converter and ordinary phase converter.
Differentiate between magnetic field and magnetic flux?
Anyone who can recommend an equivalent to Envirotemp FR3 of Cooper?
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
give me applications of sequence bridges . (used in 3 phase un balanced systems)
How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?
which is better to use svc or synchronous condenser why ?
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
how to calculate slip ring induction motor stator and rotor currents??
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
