Answer Posted / gaurav

Induction motor always operates at lagging power factor
because induction motor is a electrical machine in which
only stator is supplied and rotor gets its power through
mutual induction.In the rotor how much current lag behind
the voltage is actually depends on the material used for
rotor.

WHAT IS ELECTRICAL MAINTAINTENCE ?

2142

---

The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?

3718

---

how to calculate units consumption for a 12 hp motor /hr.

1541

---

Why hydropower stations are preferred solution for meeting peak loads in grids?

1054

---

what is the voltage between earth to neutral in lift.

1868

---

In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?

1266

---

A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.

2168

---

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

2121

---

8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......

9350

---

solor panels arrange some angle,panel is flat fitted energy was produced or not why?

1958

---

condition Autotrip facia come on control panel of electrical transmission line?

1618

---

How can I known multiplying factor .without multiplying table

1879

---

How may I enrol or get admission to your program?

1956

---

What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2) 

2880

---

full form of flry b

4212

---