Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate no load losses units comsumed by
transformer
- 2 Answers
- 8031 Views
- MRF, I also Faced
- E-Mail Answers
Answer Posted / arb555
By no load test, i.e
The O C test using w/m , a/m & v/m.
The W/M reading gives no load losse, W
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is difference between Over Current & Earth Fault protection?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
hi, could someone help me to find a control design for syncronising panel .
Atwhat condition reverse power relay will act?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
If o/p power is doubled by how much does the sound increase
Why power factor should not be in leading (capacitive) mode of any load.
Why armature rheostat is kept in maximum position?
what is sevice settings for mccb?How can be it setted?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
how to store the thunder power?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
Why the earth to phase voltage is high 250 compare to other two phases
What is the permissable nutral current of three phase system as per IS standards?
