why we connect digital multimeter in series for dc current
measurement and parallel for dc voltage measurement.
Answer Posted / syed jalal
coz in series connection current is same so wen multimeter
is connected in series it shows the same amount of current
that is flowing through the circuit and is the case with
parallel connection for voltage measurement.
| Is This Answer Correct ? | 21 Yes | 3 No |
Post New Answer View All Answers
what is the protection system in solar turbine compressor
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
How to calibrate Toxic gas detector?
If P will increase then what will happen with PID?
In turbine, what does term CDP, NI, NH, HSSOC, means
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
What is furnace draft control?
what is the calibration procedure for transweigh make weigh feeder?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
give some question relative instrument fitter?
please send data bank of quetions answers on analytical instrumentation.
What is solenoid valve? Where it is used?