When we getting shock, its we getting from voltage or
Current.
- 14 Answers
- 17292 Views
- Juniper Networks, I also Faced
- E-Mail Answers
Answer Posted / loboreliance2003
We get shock due to voltage and this voltage should be
higher than 110v. Lesser than 110v mostly we dont feel any
shock. But only above 50mA current flowing is sufficient
for the body to feel the shock. Hence ELCBs are 30mA
because if 500mA flows through the body then heart will
begin to vibrate and could lead to death. So we can
conclude that voltage higher than 110V and currents higher
than 50mA are cause for shock.Amount of Current flow
through the body is due to amount of body resistance of
the individual. This varies from person to person and also
this changes if body skin is dry or wet. Wet body then
shock is more severe.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values
is that any software calculator to calculate the size of cable
transformer phasor diagram under load explain it?
How much ph is maintained of water resistance starter for slipring induction motor ?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
is oil viscosity affect on motor current?
what is meant by moulded case circuit breaker ?
Why colled 440V to 3-phase supply.
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
How to calculate Temp from Resister from PT100 equation,
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
what is the role of energy meter in distribution system ?
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
