Which one is correct mVA or MVA. Whether both the units are
same for the transformer
- 10 Answers
- 13095 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / sunil kumar
Both mVA and MVA are correct unit but depends upon the
rating of transformer
1. mVA mean milli volt ampere, used for small rating
transformer
2. MVA means megga volt ampere used for large rating
transformer
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
why ten delta testing is carried out on power transformer
What is the previous name of Cox's Bazar
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
how unidirectional torque is produced in DC motor?
what is the IPC ? & what the uses ?
Which are resistive loads & which one are inductive loads : Refrigerator, Split air conditioner, ceiling fans, well pump, fluoresecent bulbs, T.V, CRT Monitors, Adsl Routers, C.P.U, Printers, Deep Freezers, Speakers, DVD Players, Microwave oven etc. ? Output Power for these Appliances Would be same like this : P = V * A * P.F Or would be changed ? thanks
What do you mean by pull of electromagnet?
Explain thin film resistors and wire-wound resistors
what is load vs Torque curve & why it is used?
what is 30-phase of transformer
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
how wecalculate breaking capcity of acb mcb mccb .explain with example
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what are the interview question asked in wind mill about electrical
