Answer Posted / gomsy
third wire is used as lead wire compensation i.e it is
connected in parallel,hence effective resistence decreases
and will be helpful to calculate higher range of tempreture
| Is This Answer Correct ? | 13 Yes | 4 No |
Post New Answer View All Answers
defination of radial vibration?
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
What is the principle of capacitance type level transmitter?
How many interlocks at turbine side?
Identification of ss fittings, pilot valves, relief valve.
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
what is the usage of QDV & VOLUME BOOSTER
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
How would you choose differential range?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is the use of gauge?
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
how to work MIL contol valve posistioner ?
Why do we floating DC in DC system.
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
