What is the Gap Should maintain for HT cables crossing of
LT Cable?
- 2 Answers
- 6602 Views
- I also Faced
- E-Mail Answers
Answer Posted / kirti
if the two cables are bare ones then the di-electric
strength has to be calculated between them. if they are
insulated ones then it can be kept in contact, i.e one over
other.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
No load tap changing transformer working
How to calculate Ith (I thermal) for curent transformer
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
Why have to use copper cable for local isolator to motor ?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
Why field rheostat is kept in minimum position?
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
How to find out damper winding failure for synchronous machine?
Difference between on line capacitor and Station type capacitor
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
how can we change the phase angle b/w two phase?
