Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between RTU & MTU in SCADA system?
- 4 Answers
- 50928 Views
- Bosch, I also Faced
- E-Mail Answers
Answer Posted / khyati
All the signals from remote field devices (RTU) is terminated to the Master terminal Unit(MTU) via appropriate physical medium (wired or wireless). The field signals such as pump or motor f/b , digital switches or even analog signals (4-20 ma, 0-10 v etc)are terminated to basic level to RTU .There can be 'N' no. of RTU's placed in a system which carries all the field device status to the MTU.
| Is This Answer Correct ? | 63 Yes | 0 No |
Post New Answer View All Answers
Who to difference between analog in & analog out in dcs?
What is motion balance principle?
How to erection of DCS Panel at site step by step
what is the input to be given in digital flow meter during the the calibration time?
How INtools is useful for routine Instrument maintenance?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Q- What are the application in which PNP transistor is preferred over NPN ?
What are different types of orifice plates?
How to calibrate level transmitter with use of HART?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is compensation? temprature & pressure
what is sil (safety integrity level
how to calculate control valve bonnet size?? or how to select its material?
how to measure oxygen which methods are using?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
