Answer Posted / kumar
1%= 10,000ppm
Is This Answer Correct ? | 27 Yes | 4 No |
Post New Answer View All Answers
How to decide assay range for non pharmacopeial API analysis by HPLC? Could you give me any reference for same e.g Guidelines or Paper publications?
Why use only methanol,used determinationof moisture content not use other solvents
if tech transfer fails whay require to do?
If inhouse hplc related substance method is completly diffrent from Usp for finished proďuct with diffrent impurities then how require to prove method equivalecy?
in OSD forms require to use gas chromatography?
Please tell me about the pH of Polycaboxylic ether is it in the 5-6 range ever or more than 6
why cone formation during dissolution?
what is the different in Total ash, sulphated ash, acid insoluble ash, alcoholic or non alcoholic ash?
What is the requirement for brazil in the analytical method vslidation comparr to ich?
Which products will produce when acetic anhydride reacts with Ter-butanol, Sec-butanol, Iso butanol, Dimethylamine etc.
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
What is control room temperature and which guide line says?
why octanol used to determine the partition coefficient ?
in which situation require to take incident in validation?
In Assy by potentio metry titration method how select MET U ,DET U, SET U,