Interested to Buy Any Domain ? << Click Here >> for more details...
What is an antisurge control system, how it works?
- 3 Answers
- 17250 Views
- I also Faced
- E-Mail Answers
Answer Posted / senthil.doosan@yahoo.com
it is not simple..
its complicated.
setpoints we have
-High surge flow
-low surge flow
-high surge pressure
-low surge pressure
-safety margin
for actual calculated flow we need
-molecular weight
-actual pressure
-actual temp
-flow coefficient
-internal pipe dia
-comressor flow
-density of gas
-dp
Controls:
we have
- surge flow control(Actual flow with calculated flow)
- discharge pressure control( Actual dicharge pressure with
setpoint pressure)
finaly,
the maximum of this control is given as deviation to the
master control which control the antisurge valve..
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
What are different types of orifice plates?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
what is the criteria to decide conductor size of a cable ?
What is instrumentation control?
how do we commission inergen system?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
why fuse block is not used for AI signal?
How to calibrate level transmitter with use of HART?
What is the use of each wire in three wire RTD
How to work temperature gauge?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
how to turbine speed measurement?
