Interested to Buy Any Domain ? << Click Here >> for more details...
suppose if oil in transformer is not used than what
constructional change you will do,for insulation and cooling?
- 2 Answers
- 6168 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / dharmarajsinh
cooling of transformers are based on rating of
transformer.however if oil is not to be used for same
rating than insulation lavel will be increes and than for
cooling force cooling to be provided and altimatly size of
transformer will increases.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
how to calculate the fault in substation
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
how mass curve differs from hydrograph.
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
design a LV scheme for a 15 storied building?
What happens when ac supply is given as excitation voltage instead of dc supply
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
Why GRR starts from 60% of motor speed why not less than 60%?
How can calculate the rating of a alternator for a given specific load with formula
direction of tarbine& genrator
define the active power?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
What are the different types of LT Cables?
What is meant by stator?
