Interested to Buy Any Domain ? << Click Here >> for more details...
The power required for size reduction in crushing is???
- 5 Answers
- 9667 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinayak desai
THE POWER REQUIRED FOR CRUSHING IS DEPENDS UPON THE SIZE &
DENSITY OF THE MATERIEAL
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Why does catalytic converter used in an automobile?
What is the most common carrier gas used in pneumatic conveying?
What are the some common problems associated with dilute phase pneumatic conveying?
Explain the procedure to estimate the friction factor involved in heat exchanger tubes?
Why should a magnesium ribbon be cleaned before burning in air?
In case of welded vessels why is stress relieving in the form of post-weld treatment necessary?
Explain what type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
What are some common causes of control valve noise?
What particle sizes are electrostatic precipitators used to remove?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
What is maximum recommend pipe velocity for dry and wet gases?
Are there any general rules for flushing slurry lines?
Explain how can you separate hydrogen peroxide into hydrogen and oxygen?
What does the catalytic converter on an automobile do?
After conducting an internet search for ways to reduce energy costs, I found a recipe for whitewashing that is said to reflect sunlight. The recipe calls for 20 pounds hydrated lime to 5 gallons water to 1-quart polyvinyl acetate. What is a good source of polyvinyl acetate that I can buy at a local store?
