What are the conditions to be satisfied before connecting
two DC generators in parallel?
- 9 Answers
- 14958 Views
- Bhel, Godrej, I also Faced
- E-Mail Answers
Answer Posted / bhavya
Its not actually the phase sequence in case of DC. its polarity i guess... and also the votage rating must be the same... i go with the answer 2
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
Block diagram of Power line communication?
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
boiler is running in rankine cycle and deisel generator is....?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
Tell me all plants load factors i.e which plant operating on which load?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
What is the power requirement of tamil nadu for one month?
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
Which type of questions well asked. ?
why genarator genarating voltage 11 KV?
How Can you do Maintenance of ACB of 2000Amperes
Bimetal strip used in overload relay what is that,which types of material used for that & percentage.
how to calculate
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
