HOW TO CALCULATE EACH PHASE CURRENT WHILE A MOTOR CONNECTED
TO STAR- DELTA STARTER?
- 3 Answers
- 6307 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhishek patel
When motor is started in star Il=Ip (Line current = Phase
current). While working in delta Il=_/3Ip (Line current =
root 3 phase current).
Current taken on R Y B phase is known as Line current,
while current taken on motor six terminal individually is
known as phase current.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Which power will flow first if we switch on a motor Active or Reactive? How?
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
how we design a pannel to start 10HP motor with the help of star delta starter?
Give details on how you intend to handle a challenging position you are posted to manage unexpectedly as a company staff?
how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.
where we use the SFU & FSU?
what happen when we add mentos in cold drink?& why?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
