Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean by PID controller? And what is its Long form?
- 9 Answers
- 30745 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / pravin
A proportional–integral–derivative controller (PID
controller) is a generic control loop feedback mechanism
(controller) widely used in industrial control systems – a
PID is the most commonly used feedback controller. A PID
controller calculates an "error" value as the difference
between a measured process variable and a desired setpoint.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
state the working of discharge lamp?
What are the two major types of control system?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
How phase displacement change in the over current relay coils.
how to determine ct ratio in ht vcb?
dear sir, i completed diploma in electrical in 2005, how i can get electrical supervisor liance in mumbai
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
As we use capacitor bank in 3ph ckt to improve PF, can we use capacitor in single ph domestric use, in house we have Fan,Mixer,electric cooker,iron,tube choke they also lag the system,because it is inductive load. if it is possible to improve PF of single ph system-- if yes- type of capacitor to be used,connection diagram, working in detail. if no-- list it.
Why line VTG = √3 phase VTG in star? How?
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
What is installed in PAC that is control the humidity
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
why we can use 1 to 5V dc
why is control bus bi-directional?
