Interested to Buy Any Domain ? << Click Here >> for more details...
in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
- 11 Answers
- 18062 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / hariis
its becoz its very difficult to heat an already heated
steam... becoz heat always flows from a high temperature
to low temperature easily..
so it is necessary to cool down the steam before reheating
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
How to assume answer to electrical questions
What is the operating principle of turbo-generator.
Please explain me about Relay curves and their sources to read ?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
why would amp draw on neutral wire be as much as amp draw on the hot leg.
HOW TO CALCULATE HV CABLE SIZING?
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
working of diesel generator ?
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
What is the physical significant of power factor?
what will happen if synchronous machine rotor fed from single phase ac supply
why US countries maintains 110v and 60HZ
please send me previose rrb junior engineer qustion papers
