Is there any software to prepare the Estimate of building.Plz
tell me.......
- 10 Answers
- 11379 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / prakash kedia
for estimation HIT OFFICE U CAN USE
THIS SOFTWARE HAS USED IN MY COLLEGE PUNE
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
GIVE US YOUR FULL DETAIL OF THE FOLLOWING… FULL NAME.. PERMENENT MAILING ADDRESS DIRECT CONTACT NO E MAIL ADDRES.
What is the difference between undo & redo?
What is horizon or horizontal mining?
) Design a gussetted base for a column section consisting of one sc 250 with two cover plates 300 x 25 mm carrying an axial load of 2500 KN. The S.B.C. of soil is 250 KN/m2 and the permissible bearing pressure on concrete is 4000 KN.
how to shuttering is used in slab
what is civil enginnering & what you need of this course?
why the profile of shell of natural draught cooling tower is hyperabolic.
How many lbs are there in a yard?
How to calculate Cement in bags ,sand in sqft and aggregate in sqft for 1cum M25 grade concrete
how to conversation of all construction material in to brass
Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks
how much cement and sand required for 1cum rr masonry
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
How many Rod required for 58 feet by 24 feet roof slab which is supported by 5 * 3 = 15 Column. Six Stored building Roof Slab = ? Ton 15 Column = ? Ton Slab Beam = ? Ton
Explain how you can turn off the display for dimension in CAD?
