Answer Posted / william o&

This can only be answer if the type of refractory to be
used is known. Is it LCC or ULCC or air-dry plastic or
phos-bonded plastic? More info is needed to answer this
question.

what is the max. area can we apply the plate load test ?

2403

---

how to calcualate the amount of stone,cement,sand required for 1cum of 450mm thick ruble stond masonary with ratio1:5, please me an answer with dtailed step

2175

---

what is pqc

1780

---

What do you mean by tolerance factor of concrete ?

3160

---

Define mirror?

1279

---

What are the composition of a landfill?

1251

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

2176

---

The foundations are placed below ground level, to increase?

1259

---

could u tell me how to used deform stell bar in reinforce concret?i wanna know the general using in the site!

2131

---

Required concret Surface Temperature prior to coating of epoxy pain with references ASTM or ACI whatever

2256

---

what is pouring and explain

2356

---

i have four storeyed rcc building.basement of the building is around 34 years old.it does not have pillar support.it is having lintel steel support at every 7 feet of construction. how long this building will lost long . can any body help me in this regard

2354

---

660 square fit two story house make totally how much cement, sant, brick,aggregate, steel totally how much need

1630

---

in levelling operation the first site on any change point is back site the second site on any change point is fore site the line commenses with fore sight & closes with backsight the line comensses with back sight & closes with fore sigh

2273

---

what are RIB slabs explain about it

2650

---