Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / iqbal
A motor operating continuously at a service factor greater
than 1 will have a reduced life expectancy compared to
operating at at its rated nameplate horsepower
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why do we lay up the core of a cable?
what is the effect of earth on capacitance in 3-phase and 1- phase transmission line?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
What is meant by derating factor?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what is meant by directional earth fault and non directional earth fault? describe both.
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
what is the use of expulsition protective gap in 11Kv line.
What is the dc grounding system and what is diff between AC/DC grounding system?
How to calculate size of HT breaker with the help of Amp (current)? Please provide answers with examples.
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
