how can we rotate a single phase motor (without cap.)in
reverse direction?
- 2 Answers
- 4299 Views
- I also Faced
- E-Mail Answers
Answer Posted / sri krishna
we kannot strt a 1phase motr with out kapacitr, since the
1phase motrs are not self strtng.
but without kapacitr , we kan rotate 1phase motr in either
direkt, by giving some xternal torque to the motr shaft at
at the tym of strtng.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Difference between a pilot wire and a normal conductor?
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
What are the types of feedback oscillators?
how to test and calculat the head and discharge in borewell compressor
How many double suspension hardware fittings are required on a double circuit transmission tower?
What is the difference between isolators and electrical circuit breakers?
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
what will happen if synchronous machine rotor fed from single phase ac supply
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
If o/p power is doubled by how much does the sound increase
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
What is the previous name of Cox's Bazar
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what are all types of cross section in AC cables?
