How to find the maximum load(in KW)in a big industry, having
motors,lights,lifts etc..?
- 2 Answers
- 4258 Views
- ME, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
To find actual maximum load, maximum demand meter may be
usad.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is arc flash and what are the hazards involved
what types of electrical & mechanical test conducted in switchyard?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
What are the conditions for sustained oscillator or what is backhouse criterion?
Define average demand?
What is the difference between a Root Locus plot and a Bode plot?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
