Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE USE OF TERTIARY WINDING IN A STAR/DELTA
TRANSFORMER ?
- 3 Answers
- 7981 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh kumar
the tertiary winding has a power rating below the rated
power rating of the secondary side, it is also called as
"STABILIZING WINDING". it is used for the following reasons:
A) harmonics suppression.
B) reduction of zero sequence impedences.
C) Sometimes the power is taken from it to supply fans and
cooling systems.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
how is the incoming cable size calculated for a given current rating of a panel??
what is meant by moulded case circuit breaker ?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
What is the difference between line drop and percentage line drop?
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
hey guys help me out.....what are the industrial uses/functions of nozzles in industries
What is the rate of WCT on the Electrical Contracts comprising of DG Sets and Civil Works in Delhi ?
What is the practical way to calculate the cable size for known ampere load?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
What do you mean by cogeneration? What its working principle?
i want to model paper for section engg.
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
