WHAT IS THE DIFFERENCE BETWEEN DCS & PLC.
Answer Posted / alok
where lot of no. io's are used there we used dcs this basic
difference b/w dcs and plc.
Is This Answer Correct ? | 0 Yes | 9 No |
Post New Answer View All Answers
What is instrumentation measurement?
what is gas metering system? gas chromatograph? and gas compressors?
how do calibrate the valves.. with clear manual
What is 3 selection available when configure the burnout protection for controller
all questions related to instrument technician in any offshore oil and gas company.
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What is the minimum rating availalbe for weld neck orifice in market?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
why orfice is not used for main steam flow calculation
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
send me last 5 years questions asked in rrb chennai, for section engineer
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?