Interested to Buy Any Domain ? << Click Here >> for more details...
Is Neutral earthing necessary for single phase system or
Genset? if yes or no then why?
- 1 Answers
- 4651 Views
- I also Faced
- E-Mail Answers
Answer Posted / sarwar
I think for single phase there is no need for earthing.
Earthing is useful to bypass the charge of thundering.
But incase of three phase generator we must use earthing
because, without earthing when loads are not equal among
the phases then the phase voltages are not same respect to
star point. Which is very dangerous for single phase user.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
What is the main cause of magnetism?
What are the advantages and disadvantages of the dc motors?
could you measure current in parallel?
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
what is circuit breaker in transfomer and where it used
derive DC RMS value for half wave rectifier?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
What is the purpose of stand by earth fault protection for transformer ?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
describe the A.C. Generator Testing procedure
Differentiate between low pass, high pass and band pass filter?
how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take
please give me solution to rectify the emi(electromagnetic interference)
