Interested to Buy Any Domain ? << Click Here >> for more details...
why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 68665 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh r
hi all...
i cud see the most people are asking this question..
since i got working experience in siemens ..i would like to
share the things...v used to check with ac n dc testing...
theoretically whoever have said abt ac n dc were right...
but practically its different ..v never cared abt 220v
dc..even u can touch positive or negative (not both) nothing
will happen...
but v people would feel fear while testing ac..coz if u
touch any of the wire..u will get shock for sure...n
difference between ac n dc shocks are...when u get shock in
ac ur body will vibrate like anything due to frequency..that
wil make u sick n die...
in dc ur body will not vibrate as there is no frequency...
but u feel shock(i got shock many times in dc)....
advantage over ac is dc will give u time to release from the
shock...that is..its upto ur control(when u go its
control..u cant coz of no freq)...but ac will not give u
time to release...it is not in ur control until otherwise u
pull ur hand forcely(that too some extent)...
please dont say once current comes to zero or negative so it
will leave n all....ur point is right for 1 Hz ..when it
comes to 50Hz in sec...u cant...
both r dangerous...but AC is little bit more.....
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the difference between interconnection and intraconnections in the circuit diagrams
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042
How LT megger works ?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
plz send me the procedure and syllabus for mseb exam
What is the purpose of stand by earth fault protection for transformer ?
what is earth resistance? how to measured? and give values at power station and mcc area?
transformer phasor diagram under load explain it?
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
What should be the height of basement according to NBCC code?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
how solar power plant energy meter multiplication factor
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
