Interested to Buy Any Domain ? << Click Here >> for more details...
For an 100kw generator, only 50kw of load is connected.
will the generator generate only 50kw or 100kw. if it
generate 100kw what happens to rest of the 50kw. what
happens if we connect more than 100kw of load?
- 8 Answers
- 19633 Views
- I also Faced
- E-Mail Answers
Answer Posted / raviteja nowduru
for such type conditions speed governing system will come
into picture.so generator will generate only 50 k.but all
industries will generate the full load kw and they supply it
grid to which they are connected.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
Differentiate between low pass, high pass and band pass filter?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
What type of DC motor would you see for a lift?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
in dc series motor if field wdg is shorted then
Is there any guideline say about display of earthing value near to earth pit
what & how to check the lightning arrester
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
Help need in transformer !? Hello Friends The parameters of 2300/230 v 50hz t/f is R1=0.286 ohm R`2=0.319 ohm Rc=240 ohm X1=0.73 ohm X`2=0.73 ohm Xm=49.2 ohm Secondary Load impedance ZL=0.387+J0.29 solve the exact equivalent circuit with normal voltage across primery.. I know every thing but i cant find CURRENT I1=? and I`2=? Please help me give solution or only Formula please please...
why normally Generator rating are between 11Kv to 22Kv?
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
why burdens of VTs is more than CTs?
