Why Power generation in India is at 50Hz while in America
its 60Hz so is there any advantage/Disadvantage of this ??
- 38 Answers
- 80176 Views
- Australia Visa, College School Exams Tests, Fiat, InfoPlus, L&T, NTPC, TCS, I also Faced
- E-Mail Answers
Answer Posted / shah alam
we all know that the power generation in India is at 220v at frequency 50hz but in America it is 110v at frequency 60hz,the main reason behind this is that the impedance of inductor increases with frequency and that of capacitor decreases.if we find over all impedance of the combination of inductor,capacitor and resister we can see that the current supply would increase with a little decrease of frequency.the formula for current calculation is given as..
i= v/(r^2+(wL-1/wC)^2).
where,
w=2*pi*f.
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
Give the topology of current amplifier with current shunt feedback?
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
For overhead protection we use which transformer?
what is the function of gss in the dg set.
HOW TO REDUCE POWER PLANT AUXILIARY POWER CONSUMPTION?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
What is mathematical model of a control system?
why ups rating in kva? and why ups are in parellel?.why isolation transformer is used in ups?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Alternator rotor earth fault relay circuit
