Answer Posted / senthil
1.During commissioning, we ll do loop checks.it means from
field instrument( PT,TT,FT,LT or switches) the signal is
checked with the DCS.
for example : consider a PT,we ll simulate 4 to 20 mA in the
instrument and the same value should be shown in the DCS also.
2.there are two loops
open loop and closed loop
closed loop for controllers to control the process.for
example, antisurge control in Gas Compressor,Three element
control in Boiler
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
HOW TO CALCULATE ACCURACY OF AN INSTRUMENT. WHICH IS COMPITABLE FOR USE.
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
what are the steps I have to deal with?
Explain the working of an electronic level troll.
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
State some of balance principle’ advantages?
How servomotor controls throttle valve of TURBINE?
how to check earthing,what is minum ohms for proper earthing
where i can get training in INTOOLS and PDMS in Delhi-NCR OR north part of India. please reply with ur ans. at arunsamkaria@ymail.com
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
Why thermo wells are used? What materials are used in thermo wells?
Give 2 application of quartz crystal used for process parameter measurement.
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system