Interested to Buy Any Domain ? << Click Here >> for more details...
why transformer required and why not voltage directly supply
from power generation to the applications
- 3 Answers
- 5666 Views
- I also Faced
- E-Mail Answers
Answer Posted / brijesh sojitra
bcoz at genration point it is in a.c. form nd it is
necessary converted into a.c to d.c. voltage for use in our
application so, transformar required........
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
plz anyone provide me the sample test papers of ONGC as of i m from Mechanical engg bakground and would be appearing for the test in the june 2010. My email id - neeraj_94312@rediffmail.com
What are the automatic tripping devices of diesel generator?
how to define nomenclature of bearing.
Can I use motor oil in a hydraulic system?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What is G U T protection?
please msg me tecnical question of hpcl
How the speedo meter ratio was decided for vehicle?
How to find rating of Chiller a.c. plant i.e. how to calculate the a.c. load of an area, feeded by Chiller ?
What is higher IMP or BHR
What are the thermal conductivity properties of brass?
what is the three types of combustion-control system?
hi fiends i am a diploma engineer(mech).now i am preparing for b.e mech part time course. could be send me entrance questions paper fo me .'sureshscad@rediffmail.com'
The graphite in grey irons exists in the form of flakes which act as stress-raisers under tensile loading and consequently grey irons have relatively low tensile strength and ductility. Still grey iron is extensively used in engineering. Why ?
In order to derive the torsional formulas what are the assumptions taken?
