How do you configure a Cisco switch or router? What are the
steps needed?
- 7 Answers
- 15775 Views
- Cisco, Herzing University, I also Faced
- E-Mail Answers
Answer Posted / mohit
To configure switch for routing use no switchport command
on configuration mode.It will allow your swicth to work as
router.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
pls. tell all the commands for configure cisco router 1900 series.
Give the name of protocol that is used by DNS name servers?
Hi I have 10+ years of telecom application development experience ( telecom billing product -call control (ISUP/INAP/CAMEL call handling), short message routing application, telecom tools development). I am very strong in C++/Unix , core java and advanced oops design. Recently I have undergone a training in 3G mobile protocol developement. I have very good knowledge about WCDMA, its various layers and gone through 3GPP technical specs. Now I am looking for 3G mobile development opportunities. I am finding very difficult to get it, as I don't have the relevant experiences on 3G development. Please advice me on this to enter into mobile protocol development.
What is SDP? Which signaling protocols use it?
Explain Protocols?
What is ftp used for?
Where i can get the objective type question for Voip. please let me know soon.
What are protocols? What are they used for?
Explain why is a gateway used?
A periodic composite signal with a bandwidth of 3000 Hz,is composed of two sine waves. First one has a frequency of 100 Hz with a maximum amplitude of 30 V, the second one has a maximum amplitude of 10 V. Draw the bandwidth.
How do I ftp?
Explain two-phase locking protocol.
What does ftp stand for?
What are the uses of protocols?
In UDP protocal Iam sending one immage i lost one packet in network how can i refill that packet on receving side,how can i deside total immage is receved ?
