Answer Posted / guest

for every 100V ,we gotta add 10V in order to compensate the
transmission loss.hence its in this series. its actual
story goes like this.... thomas alva edisn introduced the
first dc distribution systm..i.e, manhatten dc system.he
wanted to make one incandescent lamp glow.for that he tried
with 100V n found the lamp to glow brightly.but when this
lamp was fixed in a street corner, it did not glow with the
xpected brightness.so he made it as 110V and tried the same
n he found the lamp to glow with that original
brightness.from that time, it became a std to add 10V for
the trans loss compensation.

How line capacitance & line inductance varies with increase in height tower.

2327

---

Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?

3087

---

What is depreciation factor?

2258

---

R=*¶ l/a

1615

---

What is the necessary condition for stability.

1199

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

1870

---

what is the basic need of domestic loads 1- voltage 2- current

2100

---

design a 3 bit synchronous and asynchronous counter using T- flipflop

1999

---

What is the end effect of linear induction motor ??

2019

---

WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.

2222

---

is there any phase difference occurs while primary and secondary side mutual induction occurs?

2008

---

In motors how many types of cooling systems were used?

2065

---

1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done

1892

---

State and define norton’s theorem?

1242

---

How to configure the drives in PLC, through Profibus commnication. And to how to address it?

2827

---