Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / naresh patil
PLC is control the any one system at time but DCS can
monitoring & control many system at a time.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
why fuse block is not used for AI signal?
Explain bernoulli’s theorem. State its application.
Explain the use of hair spring in the pressure gauge.
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
What is Predictive Maintenance
Calibration procedure for electro magnetic flow meter
how to calculate control valve bonnet size?? or how to select its material?
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
What is voltage regulator?
Explain an adaptive / self-tuning controller’s major draw card.
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
