Answer Posted / sagar parmar (getco)
Oil is used for the 3 purpose,
1. it provide insulation
2. it provide cooling of the windings.
3. with using oil we can take DGA (Desolve Gas
Analysis)which help to find out internal fault of x'mer
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is sink and source?
please send previous exams question papers
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
wheather the size of windings in motor and generator are the same
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
which capacity of RCCB used for five thousand watt electricity load?
Why control of DC motor is simpler?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
how we can do the insulation on secondary of ct explain and so that tan delta will within limit
What is the difference between a verilog task and verilog function?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
A low wet bulb temperature indicates
What is size 00, 01, 1 etc., in HRC fuse types?
At what speed an electric car can run with 2 HP motor of weighing 400 kg?
