Interested to Buy Any Domain ? << Click Here >> for more details...
why the earth pin in a 3-pin socket is longer and thickest?
- 5 Answers
- 9183 Views
- I also Faced
- E-Mail Answers
Answer Posted / shivendra
we know that R=p(L/A).So as the area of cross section increases the resistance decreases AND the current follows the minimum resistance path.So in case of fault current excessive current will flow via earth pin thereby saving the human from shock.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
Whether power factor should be high or low? Why?
Why different Pressure switch used in marine boiler water circulation system
what is per unit calculation?looking for simple and strong explanation thk u
At full load wat is the motor p.f And at no load will is the motor p.f?
After synchronization with grid what is the demand value QKVAR and how we will maintain that?
Use of switch mode power converter in real-time basis?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is inrush current?
harmonics filter
