Interested to Buy Any Domain ? << Click Here >> for more details...
The cable area of cross section is 185 sq mm. How to convert this to the diameter.
- 7 Answers
- 16550 Views
- Syscon, I also Faced
- E-Mail Answers
Answer Posted / jim sreedharan
3.14 * D= 185
THEREFORE D= 185/3.14 = 58.9 MM
| Is This Answer Correct ? | 6 Yes | 6 No |
Post New Answer View All Answers
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
How to synchronization will be done between two DGs ?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
Brief working principle of stabilizer,application & safety precautions
What is the difference between relays and contactor construction wise?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
why normally Generator rating are between 11Kv to 22Kv?
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
what is gas turbine intercooling ?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
condition Autotrip facia come on control panel of electrical transmission line?
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
