Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / b.murali dhara babu
The potential equipment body some times rises to higher
value which is some times equal to the system
voltage .It is dangerous to the operating personal of the
equipment . Earthing of the equipment causes the protection
to act and isolates the faulty equipment from service .
Further it minimises the touch potential to the safe
value and helps the operating personal all times from
shocks while operating .
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Is there any abbrevation for STUB in Stub bus protection
What is PEC??Applications........
How will you utilise electrical power? You can start from the generating station.
how rectifier transformer work in electroststic precipetatore(esp?
Draw the line diagram of diffretial relay connected to transformer?
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
witch pump used in wtp
Single phase and threephase power calculation
What are the roles and responsibilities of electrical engineer in cement plant
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
What is a single phase autotransformer?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
how many types are their in switchyard or substation(like D,I TYPE), what is differant between them
If I bring a basic electric meter from the States and hook it up in Costa Rica in a development that has only one transformer for the 50 homes, will it still be accurate regarding the usage of kilowatt hours?
