Answer Posted / ajit g. k.
From thelimited amount of knowledge I have, I guess you are
meaning to know what a "black start" is. If thats the case,
I can explain to you what black start is.
A black start is referred to starting a power station from
an OFF position without the use of external energy sources.
The external energy source is mainly the power grid. In
some cases, there comes the problem that all the power
inputs to the grid may be disconnected due to wide area
outages. In that case, the power plant uses the 'internal
power sources' like diesel generators(DGs) which may be of
a rather smaller capacity. The DGs supply power for forced
draughts, controls and other auxillary requirements in the
power station.
Hope I have answered correctly. You may have read or
deciphered the question wrong. I have not yet heard of a
black star as a phenomenon or a process whatsoever in
electrical engineering. I would like to know if there is
something of that name.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what is the difference between ac motor and dc generator
what are the installation procedure of high voltage power transformer,CT,CB&PT?
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
distribution is maximum done by a)radial b)network c) parallel d)b & c
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
How the over load setting for HT Motors calculated-provided in Numerical Relay
What are the essential characteristics of signal flow graphs?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
What is routh hurwitz stability criterion?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
why using transformer and thyristor switch in 3 phase apfc panel
if a number of plc s are there then how many modbus to be used
What happen to generator if i have unbalanced load?
