which motor is suitable for traction? why?
- 15 Answers
- 47030 Views
- BCH, KPCL, I also Faced
- E-Mail Answers
Answer Posted / pradeep
well, for a traction the dc series motor will be perfectely
suited...
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
why electron produce magnetic field when it is in motion?
what is reverse power relay brief explanation and in b/w where it is connected
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
Iin ESP why positive is grounded ? why not negative ?
what are the condition that makes hooter blow?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
What is the feedback in the control system?
how indusrial diesel generator work
how to select the isolation tranformer for siemens 802dsl cnotroller
which is the best institute for PLC,SCADA,DCS in hyderabad
what is meant by moulded case circuit breaker ?
Why have to use copper cable for local isolator to motor ?
how to measure dc earth leakage current?
