Interested to Buy Any Domain ? << Click Here >> for more details...
What are the various types of BUSBAR Schemes? explain each
- 2 Answers
- 36476 Views
- Thermo, I also Faced
- E-Mail Answers
Answer Posted / masthan
types of bus bar -
1. rigid type
2. strain type
Busbar arrangements -
1.Single Busbar system
2.single busbar system with sctionalisation.
3.double busbar system with single breaker.
4.double busbar system with double breaker.
5.breaker and half scheme with two main buses.
6.main and transfer busbar scheme.
7.double busbar with bybass isolator.
8.mesh scheme (ring bus)
| Is This Answer Correct ? | 62 Yes | 4 No |
Post New Answer View All Answers
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
where was current transformer protection units used and why??
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Draw the circuit of clapp oscillator?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
12.5 tons a/c is their how much kva generator can recommend to the customer.
how maney type tempereture measurement ?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
Explain Active power,reactive power,how its related to each other , & inductive ,capacitive.
why ht motors are star connected?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
Define ampere
How much load can be taken for chiller from 1500 kva transformer
