Answer Posted / nisham
compensation is avoiding or neglecting unwanted or any
values rather than actual output.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What is instrumentation measurement?
what is the calibration procedure for transweigh make weigh feeder?
what is IEC code in cables & how to selecting cables?
What is hp & mp seperator .& what is its working principle ?
What are the types of valves?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
what is the minimum power (P=VI)to produce a spark?
What is the differerence between hysterisis and linearity.
how to relay switch sense the fault?
What is the difference between working pressure and calibration pressure of a control valve
what is the working principal of pribe
How can a d.p. Transmitter be calibrated?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
selection of the zener barrier for the hazardeous area zone 0
