Interested to Buy Any Domain ? << Click Here >> for more details...
IS RTCC AND OLTC REQUIRED FOR 500 KVA 11KV/433V TRANSFORMER
FOR AN INDUSTRY?
- 7 Answers
- 18417 Views
- IGCAR, TNEB Tamil Nadu Electricity Board, I also Faced
- E-Mail Answers
Answer Posted / kiran
there is no compulsury requirement that your transformer
with for OLTC & RTCC. Its depend on lot of condition that,
If u want supply withot interruption of line then u
required to used OLTC. Our substation transformer in MVA
rating & it has OLTC & RTCC hence there is does not
required OLTC for 500 KVA DTC. Feeder voltage controlled by
Substation person.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
how to generator maintenance (A Check, B check,Etc)
I am going to appear for the RRB Chennai junior Engineer online exam. Please send me the previous exams question papers (also solved) to my mail id: rrkhandhar@yahoo.com
how to calculate cable size in diffrent loads?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
Is there any guideline say about display of earthing value near to earth pit
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
What do you mean by a voltage transformer?
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
Why is a synchronous motor always star connected??
what is the differebt between ac and dc fuse?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
