Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bala.a
if we have two no of D.G Sets u can take supply seperately
with help of buscoupler in open condition and also u can
take combination supply with help of buscoupler closed
condition in a single panel
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What is the difference between acs 550 & acs 850
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
how to test the electrical panel.ht lt mcc pcc.
Define steady state error.
why the check zone and main zone are used for Busbar Protn. scheem?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What is the selection process of breakers. Can any one please give a formulation on same?
Use of switch mode power converter in real-time basis?
If not into production, how far did you follow the design and why did not you see it into production?
how to modify DOL control panel into Delta Y connection?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
Difference between megger test equipment and contact resistance meter test instruments?
1.What is captive power plant? 2.What is national grid?Give brief idea.
