Answer Posted / gandhikrishil
electronics is connection of computer software(e.g. PLC,DCS)
to electrical hardware(e.g. motor).
in short, electronics is connction between the hardware and
software.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
Explain PID controller tuning & any one method used for it.
What are primary elements of measuring pressure?
What is 1:1 redundancy ?
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
what is a half wave, full wave, and bridge rectifer.
What is stripper & spilitter ? Diffrence in this.?
what is interface level measurement.who can calibrate interface level measurement transmitter online
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
In turbine, what does term CDP, NI, NH, HSSOC, means
describe flow nozzel principle?
Explain signal isolator
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
