Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between LT and HT power supply?
- 26 Answers
- 187514 Views
- Center One Mall, Central University, JSW, Siemens, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / bala.a
the downstream distribution is LT supply
before downstream supply is MV ( MEDIUM VOLTAGE)
Before MV Distribution is HV (HIGH VOLTAGE )
| Is This Answer Correct ? | 47 Yes | 22 No |
Post New Answer View All Answers
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
Load break swicth maintenance procedure.
Why AC current leads voltage in capacitor and how?
explain which quantities change in the starting and the and the running condition in induction motor
how to calculate the conductor size for certain KV transmission line and distribution line?
why fractional pitch winding generally used in alternators?
Leakage current,un balance current which relay using for high voltage transmission?
How Calculet The UPS AH In Load
What is creepage distance..... what will be the value for different voltage level
If UG power cable both ends are to be earthed or what? If not why?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
explain the Trip supervision circuit
What does the a,b,c of 95a,95b,95c relays denotes?
