Interested to Buy Any Domain ? << Click Here >> for more details...
give me list of material for wiring of 20hp motor?
- 2 Answers
- 5397 Views
- Alchemist, I also Faced
- E-Mail Answers
Answer Posted / sakthivel
fully give in your motor detail and distance between motor
and main switch meter
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How dia computation perfomed in cold rolling mills .
How many types of probe used in cro?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
what is the excess air in furnace
what is alluminium arm in ab conductors
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
what is the concept of directional power?
What is trip and closing coil in cb? Why need of them
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
Draw a block diagramof Three UPS systems connected in Parallel mode?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What is an ac motor?
