Answer Posted / sakthivel
in dc system voltage and current are in phase so here no
power factor
| Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
why we use circuit breakers for switching instead of normal switching device?
why in the three pin plug all 3 pins are cutted ?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
What is an ideal transformer?
Safety of dry type transformer
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Why ground terminal is used in pot meter 10k ohms
What are the different methodes for calculating the short circuit Current?
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
describe the Operation of induction generators from bus bars
what is R Core Transformer. how it differs from normal transformers. dont search in net and post the answer.
Determine the BTU size of an aircon for 20 sq metre room
what is mean by transition resistance of transformer?
oltc of a transformer, how it works? and what are the equipment consist of describe briefly?
how to calculate maximum current
