Interested to Buy Any Domain ? << Click Here >> for more details...
At the time of 1st
charging of
transformer, there
were huge inrush
current, so why at
that diffrential relay
are not operated? Why?
- 3 Answers
- 8940 Views
- Adani, I also Faced
- E-Mail Answers
Answer Posted / m.s prabhu
THE TIME DURATION OF THE INRUSH CURRENT IS LESS SO THE CTs
WILL SATURATE, TIME DURATION OF THE INRUSH CURRENT IS LESS
THEN THE PICKUP DELAY OF THE DIFFRENTIAL RELAY.
| Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
define the active power?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
what is the difference between 2 way and 4 pole selector switch???
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
Define the three phase formula fuse.
At what factor resistance r of a conductor depends?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
what is difference between speed mode and torque mode in motor?? explain in simple words please.
what is the use of sdf?
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
How will be the single line diagram of series trip HT breaker? how it works?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
