Answer Posted / sreenu

Cable size represents one core area. First convert the area
into dia(a). The cable diameter is calculated by adding
sleeve, armour, outer sheeth dia to 3*a +1/2*a for 3 1/2
core cable. Exact size can be seen in cable manufacturers
catalogue.

What is safety of Ht panel

1662

---

Tell me about ur past electrical maintanence job

1882

---

what is the sludge current

2126

---

What is open delta Xformer? It's adavntages & Use?

2235

---

how we can explain arc heatng?

1942

---

how we can do the insulation on secondary of ct explain and so that tan delta will within limit

1937

---

HOW CAN YOU CALCULATE PRACTICAL EFFICIENCY OF A ASYNCHRONOUS INDUCTIONMOTOR OF 7.5KW,& MOTOR IS RUNNING WITH AVOLTAGE OF 410 VOLTS,& TAKING CURENT OF 13 AMPS

1880

---

Basic motor transformer generator

1494

---

HOW TO CALCULATE THE VT SIZING?

3147

---

In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..

1949

---

What is the necessary and sufficient condition for stability.

1137

---

How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)

1715

---

sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.

2230

---

What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.

3599

---

is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details

1998

---